blob: 884becf0979a0e1a88dfcdaf2d4905a9165da655 (
plain)
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
|
<section xmlns="http://docbook.org/ns/docbook"
xmlns:xlink="http://www.w3.org/1999/xlink"
xmlns:xi="http://www.w3.org/2001/XInclude"
version="5.0"
xml:id="sec-ipv4">
<title>IPv4 Configuration</title>
<para>
By default, NixOS uses DHCP (specifically, <command>dhcpcd</command>) to
automatically configure network interfaces. However, you can configure an
interface manually as follows:
<programlisting>
<link linkend="opt-networking.interfaces._name_.ipv4.addresses">networking.interfaces.eth0.ipv4.addresses</link> = [ {
address = "192.168.1.2";
prefixLength = 24;
} ];
</programlisting>
Typically you’ll also want to set a default gateway and set of name
servers:
<programlisting>
<xref linkend="opt-networking.defaultGateway"/> = "192.168.1.1";
<xref linkend="opt-networking.nameservers"/> = [ "8.8.8.8" ];
</programlisting>
</para>
<note>
<para>
Statically configured interfaces are set up by the systemd service
<replaceable>interface-name</replaceable><literal>-cfg.service</literal>.
The default gateway and name server configuration is performed by
<literal>network-setup.service</literal>.
</para>
</note>
<para>
The host name is set using <xref linkend="opt-networking.hostName"/>:
<programlisting>
<xref linkend="opt-networking.hostName"/> = "cartman";
</programlisting>
The default host name is <literal>nixos</literal>. Set it to the empty string
(<literal>""</literal>) to allow the DHCP server to provide the host name.
</para>
</section>
|
