diff options
Diffstat (limited to 'nixpkgs/nixos/doc/manual/installation/installing.xml')
-rw-r--r-- | nixpkgs/nixos/doc/manual/installation/installing.xml | 18 |
1 files changed, 11 insertions, 7 deletions
diff --git a/nixpkgs/nixos/doc/manual/installation/installing.xml b/nixpkgs/nixos/doc/manual/installation/installing.xml index 673df8f2e4c..6df1d830348 100644 --- a/nixpkgs/nixos/doc/manual/installation/installing.xml +++ b/nixpkgs/nixos/doc/manual/installation/installing.xml @@ -42,7 +42,7 @@ </para> <para> - If the text is too small to be legible, try <command>setfont ter-132n</command> + If the text is too small to be legible, try <command>setfont ter-v32n</command> to increase the font size. </para> @@ -70,9 +70,13 @@ <para> If you would like to continue the installation from a different machine you - need to activate the SSH daemon via <command>systemctl start - sshd</command>. You then must set a password for either <literal>root</literal> or - <literal>nixos</literal> with <command>passwd</command> to be able to login. + can use activated SSH daemon. You need to copy your ssh key to either + <literal>/home/nixos/.ssh/authorized_keys</literal> or + <literal>/root/.ssh/authorized_keys</literal> (Tip: For installers with a + modifiable filesystem such as the sd-card installer image a key can be manually + placed by mounting the image on a different machine). Alternatively you must set + a password for either <literal>root</literal> or <literal>nixos</literal> with + <command>passwd</command> to be able to login. </para> </section> </section> @@ -146,7 +150,7 @@ partition. It uses the initially reserved 512MiB at the start of the disk. <screen language="commands"><prompt># </prompt>parted /dev/sda -- mkpart ESP fat32 1MiB 512MiB -<prompt># </prompt>parted /dev/sda -- set 3 boot on</screen> +<prompt># </prompt>parted /dev/sda -- set 3 esp on</screen> </para> </listitem> </orderedlist> @@ -513,7 +517,7 @@ Retype new UNIX password: ***</screen> <prompt># </prompt>parted /dev/sda -- mkpart primary 512MiB -8GiB <prompt># </prompt>parted /dev/sda -- mkpart primary linux-swap -8GiB 100% <prompt># </prompt>parted /dev/sda -- mkpart ESP fat32 1MiB 512MiB -<prompt># </prompt>parted /dev/sda -- set 3 boot on</screen> +<prompt># </prompt>parted /dev/sda -- set 3 esp on</screen> </example> <example xml:id="ex-install-sequence"> @@ -550,7 +554,7 @@ Retype new UNIX password: ***</screen> # Note: setting fileSystems is generally not # necessary, since nixos-generate-config figures them out # automatically in hardware-configuration.nix. - #<link linkend="opt-fileSystems._name__.device">fileSystems."/".device</link> = "/dev/disk/by-label/nixos"; + #<link linkend="opt-fileSystems._name_.device">fileSystems."/".device</link> = "/dev/disk/by-label/nixos"; # Enable the OpenSSH server. services.sshd.enable = true; |